Repeatable
contact UT
We integrate robotic ultrasonic inspection — your robot, your UT/PAUT/TFM — for welds, curves and constrained sites. Today: filmed lab demo. Next: PoCs.
Three doors into the same cell.
Same integrator, same vendor-agnostic stack — land on the job you actually have.
Weld inspection
Contact UT on weld paths where access and angle fight a hand scan.
Curved geometry
Replayable probe paths on off-catalog curves and nozzles.
Constrained sites
Cell workflows where setup time and repeatability decide whether the scan is usable.
What is proven, and what is still under discussion.
The filmed lab cell is the hard proof. Partner and field cards below are early technical exchange — no signed customers, no revenue claims.
Contact UT path on a test coupon
FactContact UT filmed on real hardware; PAUT and TFM to validate in a PoC.
MeasureAbout 30 minutes for the full contact-UT cycle, measured on the filmed part only. Not a guaranteed turnaround, and not a figure for PAUT or TFM.
Coupling & acquisition with UT vendors
NoteTechnical exchange — not a signed partnership.
Multi-brand motion ↔ UT sync
NoteEarly talks on sync layers — not productized.
Field talks — aerospace & energy
NoteEarly technical exchange — not signed customers.
Watch the lab demo — or send us your part.
Filmed proof on a test coupon. Then we define what a cell would require for your part.